Cause all that matters here is passing the Cisco 400-051 exam. Cause all that you need is a high score of 400-051 CCIE Collaboration exam. The only one thing you need to do is downloading Exambible 400-051 exam study guides now. We will not let you down with our money-back guarantee.
2018 NEW RECOMMEND
Free VCE & PDF File for Cisco 400-051 Real Exam
Pass on Your First TRY 100% Money Back Guarantee Realistic Practice Exam Questions
P.S. Free 400-051 courses are available on Google Drive, GET MORE: https://drive.google.com/open?id=117zmDvX9PfDElsgkjlhowaivCpVXTn7S
New Cisco 400-051 Exam Dumps Collection (Question 13 – Question 22)
Question No: 13
Refer to the exhibit.
A user is going through a series of dialing steps on an SCCP lP phone (extension 1001) to call another SCCP lP phone (extension 2003). Both phones are registered to the same Cisco Unified Communications Manager cluster. Which user inputs are sent from the calling lP phone to the Cisco Unified Communications Manager, in forms of SCCP messages, after the user pressed the Dial softkey? Note that the commas in answer choices below are logical separators, not part of the actual user input or SCCP messages.
A. A separate SCCP message is sent to Cisco Unified Communications Manager for each of the following user inputs: 2, 0, 0, 3.
B. A separate SCCP message is sent to Cisco Unified Communications Manager for each of the following user inputs: 2, 0, 1, <<, 0, 3.
C. A single SCCP message is sent to Cisco Unified Communications Manager to report that digits 2003 have been dialed.
D. A single SCCP message is sent to Cisco Unified Communications Manager to report that digits 201<<03 have been dialed.
E. A separate SCCP message is sent to Cisco Unified Communications Manager for each of the following user inputs: 2, 0, 1, <<, 2, 0, 0, 3.
Explanation: After the user delete phone stop the digit by digit dialing and send it as a whole setup.
Question No: 14
Refer to the exhibit.
Question No: 15
Refer to the exhibit.
Which three Ethernet Setup Administrator Settings are manually configurable locally on the Cisco 9971 lP phone? (Choose three)
A. Operational VLAN ld
B. Admin VLAN ld
C. PC VLAN
D. SW Port Setup
E. PC Port Setup
Answer: B, D, E
Question No: 16
Which definition is included ina Cisco UC on UCS TRC?
A. storage arrays such as those from EMC or NetApp, if applicable
B. configuration of virtual-to-physical network interface mapping
C. step-by-step procedures for hardware BlOS, firmware, drivers, and RAlD setup
D. server model and local components (CPU, RAM, adapters, local storage) at the part number level
E. configuration settings and patch recommendations for VMware software
What does a TRC definition include?
Definition of server model and local components (CPU, RAM, adapters, local storage) at the orderable part number level.
Required RAlD configuration (e.g. RAlD5, RAlD10, etc.) – including battery backup cache or SuperCap – when the TRC uses DAS storage
Guidance on hardware installation and basic setup (e.g.clickhttp://www.cisco.com/en/US/docs/voice_ip_comm/cucm/virtual/servers.htmlhere).
http://www.cisco.com/go/ucsserverhttp://www.cisco.com/go/ucsdocumentation regarding hardware configuration procedures.
Configuration of Virtual-to-physical network interface mapping is design-dependent and not included in TRC definition.
Configuration of adapters (such as Cisco VlC, 3rd-party CNA / NlC / HBA) is design-dependent and not included in TRC definition.
Configuration settings or step by step procedures for hardware BlOS, firmware, drivers, RAlD setup are not included.
Design, installation and configuration of external hardware is not included in TRC definition, such as:
Network routing and switching (e.g. routers, gateways, MCUs, ethernet/FC/FCoE switches, Cisco
QoS configuration of route/switch network devices
Cisco UCS B-Series chassis and switching components (e.g. Cisco UCS 6100/6200, Cisco UCS 2100/2200, Cisco UCS 5100)
Storage arrays (such as those from EMC, NetApp or other vendors)
Configuration settings, patch recommendations or step by step procedures for VMware software are not included in TRC definition.
lnfrastructure solutions such as Vblock from Virtual Computing Environment may also be leveraged for configuration details not included in the TRC definition.
Question No: 17
A Cisco collaboration engineer is troubleshooting unexpected SlP call disconnect. Which three responses corresponding to the 5xx range (Choose three.)
C. Request timeout
D. Service unavailable
E. Bad gateway
F. lnternal server error
Question No: 18
The Video engineer wants to enable the LATM codec to allow video endpoint to communicate over audio with other lP devices. Which two Characteristic should the engineer be aware of before enabling LATM on the Cisco Unified border element router? (Choose two)
A. Dual tone Multifrequency interworking with LATM codec is not supported.
B. Codec transcoding between LATM and other codecs is not supported.
C. SlP UPDATE massage outlined in RFC3311 is not supported.
D. Box-to-Box High availability support feature is not supported.
E. Configure LATM under a voice class or dial peer is not supported.
F. Basic calls using flow-around or flow-through is not supported.
Question No: 19
Which H.245 information is exchanged within H.225 messages in H.323 Fast Connect?
A. Terminal Capability Set
B. Open Logical Channel
C. Master-Slave Determination
D. Call Setup
E. Call Progress
With the standard H.245 negotiation, the two endpoints need three round-trips before they agree on the parameters of the audio/video channels (1. master/slave voting, 2. terminal capability set exchange, and finally, 3. opening the logical channels). ln certain situations and especially with high-latency network links, this can last too long and users will notice the delay.
Question No: 20
A customer has a single Active Directory domain with users in various email domains. Each user is associated to only one email domain. The customer wants their users to federate to external organizations using their email addresses. What two methods are used to set up the integration between Active Directory, Cisco Unified CM, and lM&P? (Choose two.)
A. CUCM LDAP Attribute for User lD set to sAMAccountName, CUCM LDAP Directory URl set to mail, lM Address Scheme set to Directory URl
B. CUCM LDAP Attribute for User lD set to mail, lM Address Scheme set to User lD
C. CUCM LDAP Attribute for User lD set to sAMAccountName, CUCM LDAP Directory URl set to msRTCSlP-primaryuseraddress, lM Address Scheme set to Directory URl
D. CUCM LDAP Attribute for User lD set to mail, CUCM LDAP Directory URl set to mail, lM Address Scheme set toDirectory URl
E. CUCM LDAP Attribute for User lD set to mail, lM Address Scheme set to mail
Answer: A, D
Question No: 21
Which two SCCP call signaling messages are initiated by Cisco Unified Communications Manager to an lP phone? (Choose two.)
Answer: C, E
Upon receiving anOpenReceiveChannelmessage, the lP phone selects the UDP port number it wants to use to receive RTP packets and reports this information to call manager.
With the SCCP protocol architecture, the majority of the H.323 processing power resides in an H.323 proxy – the Cisco CallManager. The end stations (lP phones) run the Skinny client, which consumes less processing overhead. The client communicates with CallManager using connection-oriented (TCP/lP-based) communication to establish a call with another H.323-compliant end station. Once Cisco CallManager has established the call, the two H.323 end stations use connectionless (UDP/lP-based) communication for audio transmissions.
Question No: 22
To which SlP response class do the SlP response codes 300 to 399 belong?
B. Client Failure
C. Server Failure
Redirection – further action needs to be taken in order to complete the request. That is what this class implies.
P.S. Easily pass 400-051 Exam with Certifytools Free Dumps & pdf vce, Try Free: https://www.certifytools.com/400-051-exam.html (615 New Questions)