H12-811_V1.0 | The Most Up-to-date Guide To H12-811_V1.0 Actual Exam

NEW QUESTION 1

The G0/0/1 interface configuration information of router A is shown in the figure. Which of the following statements are correct? () (Multiple Choice Questions)

• A. The interface will not forward the received FTP packets
• B. This interface can establish OSPF neighbor relationships with other routers
• C. This interface will not forward ICMP packets
• D. This interface will not forward received SNMP packets

Answer: AD

NEW QUESTION 2

• A. 2
• B. 3
• C. 4

Answer: B

NEW QUESTION 3

Wireless access controller (AC, Access Cntroller) As a unified management and control device in the FIT AP architecture, the following description of the role of AC. is wrong ()

• A. No matter when the data is forwarded, the user's data message will be forwarded by AC.
• B. User access control
• C. User access authentication
• D. AP configuration delivery

Answer: A

NEW QUESTION 4

PPPoE sessions can only use CHAP authentication ()

• A. True
• B. False

Answer: B

NEW QUESTION 5

When adopting LACP mode for link aggregation, what is the default system interference level of Huawei switches? ()

• A. A.-36864B.4096C.24576D.32768

Answer: D

NEW QUESTION 6

The router enables the FTP service, the user name and password are both huawei, and the root directory of FTP is set to flash:/dhcp/. Which of the following commands must be configured?*

• A. ftp server enable
• B. local-user huawoi ftp-directory flash:/dhcp/
• C. local -user huawei passrorD.cipher Huawei
• D. local-user huawei service-type ftp

Answer: ABCD

NEW QUESTION 7

Which category does the IPv6 address FE80:2E0:FCFF:FE6F:4F36 belong to? ()

• A. Link local address
• B. Global semicast address
• C. Anycast address

Answer: B

NEW QUESTION 8

When deploying ACL on Huawei equipment, which of the following descriptions is correct is ()

• A. When calling ACL under the interface, it can only be applied to the outbound direction
• B. ACL can match the TCP/UDP port number of the packet, and can specify the range of port numbers
• C. ACL cannot be used to filter OSPF traffic, because COSPF traffic does not use UDP protocol encapsulation
• D. The same ACL can be called under multiple interfaces
• E. When ACL defines rules, it can only proceed in the order of 10, 20, 30

Answer: D

NEW QUESTION 9

Which of the following routing protocols has the highest priority?

• A. Direct
• B. Static
• C. OSPF

Answer: B

NEW QUESTION 10

What elements can NAPT convert? ()

• A. Only MA
• B. address
• C. IP address + port number
• D. MA
• E. Address + port number
• F. Only IP address

Answer: B

NEW QUESTION 11

Which state does the 0SPF protocol use to indicate that the adjacency relationship has been established? ()

• A. Full
• B. 2-way
• C. Attempt
• D. Down

Answer: A

NEW QUESTION 12

As shown in the figure, is the description of this network topology correct? () (Single-choice question)

• A. There are 6 broadcast domains in this network
• B. There are 12 conflict domains in this network
• C. There are 6 conflict domains in this network
• D. There are 2 broadcast domains in this network

Answer: D

NEW QUESTION 13

As shown in the figure below, assuming that the other configurations of the switch are kept in the default state, which port of the following switch will become the designated port? () (Multiple Choice Questions)

• A. G0/0/1 of SWB
• B. SWC's G0/0/2
• C. SWA's G0/0/3
• D. SWC's G0/0/1

Answer: AC

NEW QUESTION 14

Both pwD. and dir commands in the VRP operating platform can view the file information in the current directory, ()

• A. True
• B. False

Answer: B

NEW QUESTION 15

By default, it takes at least 30s for the port status in the STP protocol to change from Disable D. to Forwarding status. ()

• A. True
• B. False

Answer: A

NEW QUESTION 16
......