Free 300-410 Exam Braindumps

- (Exam Topic 2)
Refer to the exhibit.

A network administrator configured mutual redistribution on R1 and R2 routers, which caused instability in the network. Which action resolves the issue?

1. A. Set a tag in the route map when redistributing EIGRP into OSPF on R1. and match the same tag on R2 to deny when redistributing OSPF into EIGRP.
2. B. Set a tag in the route map when redistributing EIGRP into OSPF on R1. and match the same tag on R2 to allow when redistributing OSPF into EIGRP.
3. C. Advertise summary routes of EIGRP to OSPF and deny specific EIGRP routes when redistributing into OSPF.
4. D. Apply a prefix list of EIGRP network routes in OSPF domain on R1 to propagate back into the EIGRProuting domai

Correct Answer: A
When doing mutual redistribution at multiple points (between OSPF and EIGRP on R1 & R2), we may create routing loops so we should use route-map to prevent redistributed routes from redistributing again into the original domain.
In the below example, the route-map “SET-TAG” is used to prevent any routes that have been redistributed into EIGRP from redistributed again into OSPF domain by tagging these routes with tag 1:

- (Exam Topic 3)
Refer to the exhibit.

A NOC team receives a ticket that data traffic from RA to RF is not forwarded when the link between the RC-RE path goes down. All routers learn loopback IP through the IGP protocol. Which configuration resolves?

1. A. RD(config)#router bgp B5201RD(config-router)# neighbor 10.10.10.2 update-source loopback 0
2. B. RD(config-router)# neighbor bgp 65101RB(config-router)# neighbor 10.10.10.3 ebgp-multihop 3
3. C. RB(config)# router bgp 65101RB(config)#neighbor 10.10.10.3 update-source loopback 0
4. D. RD(config)# router bgp 65201RDI(config-router)# neighbor 10.10.10.2 ebgp-multihop 3

Correct Answer: B

- (Exam Topic 1)
Refer to the exhibit.

An administrator noticed that after a change was made on R1, the timestamps on the system logs did not match the clock. What is the reason for this error?

1. A. An authentication error with the NTP server results in an incorrect timestamp.
2. B. The keyword localtime is not defined on the timestamp service command.
3. C. The NTP server is in a different time zone.
4. D. The system clock is set incorrectly to summer-time hours.

Correct Answer: B

- (Exam Topic 3)
Refer to the exhibit.

R1 is configured with IP SLA to check the availability of the server behind R6 but it kept failing. Which configuration resolves the issue?

1. A. R1(config)# ip sla 700R1(config-track)# delay down 30 up 20
2. B. R1(config)# ip sla 700R1(config-track)# delay down 20 up 30
3. C. R1(config)# track 700 ip sla 700 R1(config-track)# delay down 30 up 20
4. D. R1(config)# track 700 ip sla 700 R1(config-track)# delay down 20 up 30

Correct Answer: C

- (Exam Topic 1)
An engineer configured the wrong default gateway for the Cisco DNA Center enterprise interface during the install. Which command must the engineer run to correct the configuration?

1. A. sudo maglev-config update
2. B. sudo maglev install config update
3. C. sudo maglev reinstall
4. D. sudo update config install

Correct Answer: A