Free 300-425 Exam Braindumps

Which CLI command does an engineer use to validate that the redundancy peer of a Stateful Switchover pair of controllers is up and connected?

1. A. rping
2. B. ping
3. C. eping
4. D. mping

Correct Answer: B

An engineer is reducing the subnet size of the corporate WLAN by segmenting the VLAN into smaller subnets. Clients will be assigned a subnet by location. Which type of groups can the engineer use to map the smaller subnets to the corporate WLAN?

1. A. WLC port groups
2. B. RF groups
3. C. AP groups
4. D. interface groups

Correct Answer: D

A customer has two Cisco 550B WLCs that manage all the access points in their network and provide N+1 redundancy and load balancing. The primary Cisco WLC has 60 licenses and the secondary Cisco WLC has 40. The customer wants to convert the N+1 model to an HA model and provide SSO. Configuration must be performed during a maintenance window. After performing all the configurations on both controllers, the config redundancy unit secondary command is issued on the secondary Cisco WLC and it fails. Which parameter needs to be in place to complete the configuration?

1. A. A cable in the RP port
2. B. The secondary Cisco WLC needs a minimum of 50 base licenses
3. C. The primary Cisco WLC is already set as the secondary unit.
4. D. SSO needs to be enabled

Correct Answer: B

Refer to the exhibit.

An enterprise has offices spread around the globe. The APs are connected to different controllers installed in separate datacenters. The IT team wants to allow clients to roam from controllers in group ABC to controllers in group XYZ. Which feature must be incorporated in the design to accomplish this task?

1. A. switch peer group
2. B. workgroup bridge
3. C. mDNS gateway
4. D. mobility lists

Correct Answer: D

A customer is running a guest WLAN with a foreign/export-anchor setup. There is one anchor WLC in the US and two in Europe. Anchor WLC priorities are used to prefer local anchors. During a routine network audit, it is discovered that a large number of guest client sessions in the US are anchored to the WLCs in Europe.
Which reason explains this behavior?

1. A. The foreign WLC failed and recovered.
2. B. The US anchor WLC failed and recovered.
3. C. The US anchor WLC is anchored to itself with a priority value of zero.
4. D. The anchor WLC is in the same mobility group.

Correct Answer: B
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-1/Enterprise-Mobility-8-1-Design-Guide/Enterprise