Free 350-501 Exam Braindumps

An engineer must implement QoS to prioritize traffic that requires better service throughout the network. The engineer started by configuring a class map to identify the high-priority traffic. Which additional tasks must the engineer perform to implement the new QoS policy?

1. A. Attach the class map to a policy map that sets the minimum bandwidth allocated to the classified traffic and designates the action to be taken on the traffic.
2. B. Attach the class map to a policy map that designates the action to be taken on the classified traffic and then attach the policy map to an interface using a service policy.
3. C. Attach the class map to a policy map within a VRF to segregate the high-priority traffic and then attach the policy map to an interface in another VRF.
4. D. Create a route map to manipulate the routes that are entered into the routing table and then attach the route map to an interface using a service policy.

Correct Answer: B

A router is configured to perform MPLS LDP graceful restart.
Which three steps are included when the RP sends an LDP initialization to a neighbor to establish an LDP session? (Choose three)

1. A. Reconnect Timeout field
2. B. Learn from Neighbor (N) flag, set to 1
3. C. Graceful restart capability in OPEN message
4. D. Recovery Time field
5. E. Learn from Network (L.) flage, set to 1
6. F. Type-9 LSA

Correct Answer: ADE

An engineer is developing a configuration script to enable dial-out telemetry streams using gRPC on several new devices. TLS must be disabled on the devices. Which configuration must the engineer apply on the network?
A)

B)

C)

D)

1. A. Option A
2. B. Option B
3. C. Option C
4. D. Option D

Correct Answer: A

Refer to the exhibit:

An engineer is preparing to implement link aggregation configuration. Which statement al about this configuration is true?

1. A. The switch port actively sends packets to negotiate an EtherChannel using PAgP
2. B. The switch port accepts LACP and PAgP packets from a connected peer and negotiate an EtherChannel using the common EtherChannel mode.
3. C. The switch port passively negotiates an EtherChannel if it receives PAgP packets from a connected peer
4. D. The switch port negotiates an EtherChannel if it receives LACP packets from a connected peer

Correct Answer: A

Refer to the exhibit.

A network administrator implemented MPLS routing between routers R1, R2, R3, and R4. AToM is configured between R1 and R4 to allow Layer 2 traffic from hosts on RA1 and RA2. A targeted MPLS session is established between R1 and R4. Which additional action must the administrator take on all routers so that LDP synchronization occurs between connected LDP sessions?

1. A. Disable the MPLS LDP IGP sync holddown.
2. B. Configure OSPF or IS-IS as the routing protocol.
3. C. Configure EIGRP as the routing protocol using stub areas only.
4. D. Enable MPLS LDP sync delay timers.

Correct Answer: A