Free 350-801 Exam Braindumps

An engineer configures a SIP trunk for MWI between a Cisco UCM cluster and Cisco Unity Connection. The Cisco UCM cluster fails to receive the SIP notify messages. Which two SIP trunk settings resolve this issue? (Choose two.)

1. A. accept out-of-dialog refer
2. B. accept out-of-band notification
3. C. transmit security status
4. D. allow changing header
5. E. accept unsolicited notification

Correct Answer: AE

An engineer is integrating Unity Connection with Cisco UCM. Which two actions must be configured so that recording and playback from the IP phones works at all times, including peak traffic hours? (Choose two.)

1. A. Increase the number of voice ports.
2. B. If it's a Unity Connection Cluster, ensure that replication is fine and not in split-brain mode.
3. C. The phone system to which the phones are registered in Unity Connection has the Default Trap Switch check box enabled.
4. D. Add dedicated dial-out ports with the allow trap connections setting selected.
5. E. Ensure that you have set up SIP Digest Authentication on the SIP trunk security profile.

Correct Answer: AB

Refer to the exhibit.

A user takes a phone from San Francisco to New York for a short reassignment. The phone was set up to use the San Francisco device pool, and device mobility is enabled on the Cisco UCM. The user makes a call that matches a route pattern in a route list that contains the Standard Local Route Group. To where does the call retreat?

1. A. The call fails because device mobility is turned on, and the phone is not configured in New Yor
2. B. The engineer must configure which sites the device should be roaming to.
3. C. The call egresses in San Francisco because the user uses device mobility and is allowed to roam while still keeping the number and resources assigned in San Francisco.
4. D. The call fails because the Standard Local Route Group is being used only it no configuration is set for the device pools.
5. E. The call egresses in New York because the device automatically is assigned a New York device pool and uses the local gateway.

Correct Answer: B

User A Calls user. The call gets connected, but the quality is bed. What are two reasons for this issue? (Choose two)

1. A. Incorrect partition
2. B. No region relationship
3. C. Network congestion
4. D. Incorrect QoS
5. E. Incompatible codec

Correct Answer: CD

Cisco UCM delays routing of a call during digit analysis with an overlapping dial plan. How long is the default wait time?

1. A. 5 seconds
2. B. 10 seconds
3. C. 15 seconds
4. D. 20 seconds

Correct Answer: C