Free 300-410 Exam Braindumps

- (Exam Topic 3)

Refer to the exhibit. The client server but the show command does not show the IPv6 DHCP bindings on the server. Which action resolves the issue?

1. A. Extend the DHCP lease time because R1 removed the IPv6 address earlier after the lease expired.
2. B. Configure H1 as the DHCP client that manually assigns the IPv6 address on interlace e0/0..
3. C. Use the 2001:DBB:BAD:C0DE::/64 prefix for the DHCP pool on R1.
4. D. Configure authorized DHCP servers to avoid IPv6 addresses from a rogue DHCP server.

Correct Answer: C

- (Exam Topic 3)

Refer to the exhibit Which action ensures that 10 10 10 0/24 reaches 10 10 20 0/24 through the direct link between R1 and R2?

1. A. Configure R1 and R2 LAN links as nonpassive.
2. B. Configure R1 and R2 links under area 1
3. C. Configure OSPF link cost to 1 between R1 and R2
4. D. Configure OSPF path cost to 3 between R1 and R2

Correct Answer: B

- (Exam Topic 3)
Refer to the exhibit.


The network operation team observes a traffic forwarding issue between R2 and R3:
Ping and traceroute of loopback IP address from R2 to R3 is successful.
iBGP peering in AS 65101 and AS 65201 is up. Which configuration resolves the issue?

1. A. Configure MD5 password authentication on R2.
2. B. Advertise R2 and R3 loopback IPs in AS 65101 and AS 65201.
3. C. Remove MD5 password authentication on R3.
4. D. Set up eBGP multihop on R2 and R3 routers.

Correct Answer: D

- (Exam Topic 3)
A newly Installeo router starts establishing an LDP session from another MPLS router to which it is not directly connected. Which LDP message type responds by target router to the Initiating router using UDP protocol?

1. A. notification message
2. B. session message
3. C. extended discovery message
4. D. advertisement message

Correct Answer: C

- (Exam Topic 3)
Refer to the exhibit.


A network administrator sets up an OSPF routing protocol for a DMVPN network on the hub router. Which configuration required to establish a DMVPN tunnel with multiple spokes?

1. A. ip ospf network point-to-multipoint on both spoke routers
2. B. ip ospf network point-to-point on the hub router
3. C. ip ospf network point-to-multipoint on One spoke router
4. D. ip ospf network point-to-point on both spoke routers

Correct Answer: A