Free 300-615 Exam Braindumps

DRAG DROP
A firmware upgrade on a fabric interconnect fails. A bootflash contains a valid image. Drag and drop the recovery steps from the left onto the correct order on the right.
Select and Place:
Solution:


Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A

Refer to the exhibit. vPC between switch1 and switch2 is not working. Which two actions are needed to fix the problem? (Choose two.)

1. A. Match vPC domain ID between the two devices.
2. B. Configure IP address on the interface.
3. C. Activate VLANs on the vPC.
4. D. Configure vPC peer link and vPC peer keepalive correctly.
5. E. Configure one of the switches as primary for the vPC.

Correct Answer: AC

Refer to the exhibit. An OSPF adjacency between Router-A and Router-B cannot reach the FULL state. Which action resolves the issue?

1. A. Adjust the MTU on Router-A to 1600.
2. B. Disable the check of the MTU value.
3. C. Set the OSPF media type to point-to-point.
4. D. Adjust the MTU on Router-B to 1604.

Correct Answer: B

DRAG DROP
An engineer is troubleshooting issues in Cisco UCS Director. Drag and drop the possible causes from the left onto the correct issues on the right.
Select and Place:
Solution:


Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A

A mission-critical server is connected to site A. Connectivity to this server is lost from site B because the MAC route is missing in the OTV VDC of the Nexus 7000 in site B due to MAC aging. Which action allows the flooding of the unknown unicast MAC on the Nexus 7000 in the OTV VDC?

1. A. Use route-map to advertise this MAC statically and redistribute with ISIS.
2. B. Unknown unicast flooding is not allowed.
3. C. Use the otv flood mac <> command to selectively flood traffic for a given MAC.
4. D. Use the otv isis bfd <> command to configure BFD protocol.

Correct Answer: B