Free 300-615 Exam Braindumps

Refer to the exhibit. After a failover occurs, which two actions must be performed on Switch-B to manually preempt the operational primary role back to Switch-A? (Choose two.) A. Configure the local vPC role priority to have a lower value than Switch-A.

1. A. Configure the local vPC role priority to have a higher value than Switch-A.
2. B. Disable and then re-enable the vPC peer-keepalive link.
3. C. Configure the local vPC role priority to have the same value as Switch-A.
4. D. Disable and then re-enable the vPC peer link.

Correct Answer: BE

An engineer is troubleshooting a packet flow from an access leaf to spine. Which EVPN routes are expected on this connection?

1. A. EVPN Type 1-5
2. B. EVPN Type 0,9,15
3. C. EVPN Type 9-15
4. D. EVPN Type 0,16

Correct Answer: A

An engineer is troubleshooting a fabric discovery failure. Which two requirements must an engineer verify about switch connectivity to solve the problem? (Choose two.)

1. A. A Cisco APIC must be attached to a spine node only.
2. B. A Cisco APIC must be attached to leaf nodes.
3. C. Spine nodes must connect to other spine nodes.
4. D. A Cisco APIC must be dual-attached to two separate spine nodes.
5. E. Leaf nodes must connect to spine nodes only.

Correct Answer: BE

An IOM fails during a firmware upgrade and is unresponsive. Which action recovers the module?

1. A. Restore UCSM configuration from backup.
2. B. Roll back to the previous firmware.
3. C. Use AutoInstall to reinstall the firmware.
4. D. From the peer IOM, reset the faulty module.

Correct Answer: B

An upgrade of protected RPMs from the Bash shell did not take effect. Which action is required for the changes to take effect?

1. A. Restart the Bash shell.
2. B. Reload the switch.
3. C. Upgrade the RPMs from the Guest shell.
4. D. Disable and reenable the Bash feature.

Correct Answer: D