Free 350-401 Exam Braindumps

- (Exam Topic 1)
Refer to exhibit.

VLANs 50 and 60 exist on the trunk links between all switches All access ports on SW3 are configured for VLAN 50 and SW1 is the VTP server Which command ensures that SW3 receives frames only from VLAN 50?

1. A. SW1 (config)#vtp pruning
2. B. SW3(config)#vtp mode transparent
3. C. SW2(config)=vtp pruning
4. D. SW1 (config >»vtp mode transparent

Correct Answer: A
SW3 does not have VLAN 60 so it should not receive traffic for this VLAN (sent from SW2). Therefore we should configure VTP Pruning on SW3 so that SW2 does not forward VLAN 60 traffic to SW3. Also notice that we need to configure pruning on SW1 (the VTP Server), not SW2.

- (Exam Topic 4)
Refer to the exhibit.

The server in DC2 is expecting traffic from the database in DC1 to use the source network of 10.50.250.0/24. The server sends the initial request. The inside global IP is configured for 10.50.250.1. What is the result of this configuration?

1. A. Only the server can initiate communication.
2. B. The server and the database cannot communicate.
3. C. The server and the database can initiate communication.
4. D. Only the database can initiate communication

Correct Answer: C

- (Exam Topic 4)

Refer to the exhibit. Which command set completes the ERSPAN session configuration?

1. A. Option A
2. B. Option B
3. C. Option C
4. D. Option D

Correct Answer: A

- (Exam Topic 2)
A network monitoring system uses SNMP polling to record the statistics of router interfaces The SNMP queries work as expected until an engineer installs a new interface and reloads the router After this action, all SNMP queries for the router fail What is the cause of this issue?

1. A. The SNMP community is configured incorrectly
2. B. The SNMP interface index changed after reboot.
3. C. The SNMP server traps are disabled for the interface index
4. D. The SNMP server traps are disabled for the link state.

Correct Answer: B

- (Exam Topic 2)

Refer to the exhibit. Router BRDR-1 is configured to receive the 0.0.0.0/0 and 172.17.1.0/24 network via BGP and advertise them into OSPF are 0. An engineer has noticed that the OSPF domain is receiving only the 172.17.1.0/24 route and default route 0.0.0.0/0 is still missing. Which configurating must engineer apply to resolve the problem?

1. A. Option A
2. B. Option B
3. C. Option C
4. D. Option D

Correct Answer: D