Free 350-401 Exam Braindumps

- (Exam Topic 4)

Refer to the exhibit. Which set of commands is required to configure and verify the VRF for Site 1 Network A on router R1?

1. A. Option A
2. B. Option B
3. C. Option C
4. D. Option D

Correct Answer: D

- (Exam Topic 2)
Which OSPF networks types are compatible and allow communication through the two peering devices?

1. A. broadcast to nonbroadcast
2. B. point-to-multipoint to nonbroadcast
3. C. broadcast to point-to-point
4. D. point-to-multipoint to broadcast

Correct Answer: A
The following different OSPF types are compatible with each other:
+ Broadcast and Non-Broadcast (adjust hello/dead timers)
+ Point-to-Point and Point-to-Multipoint (adjust hello/dead timers)
Broadcast and Non-Broadcast networks elect DR/BDR so they are compatible. Point-topoint/ multipoint do not elect DR/BDR so they are compatible.

- (Exam Topic 4)
Which device, in a LISP routing architecture, receives and de-encapsulates LISP traffic for endpoints within a LISP-capable site?

1. A. MR
2. B. ETR
3. C. OMS
4. D. ITR

Correct Answer: B

- (Exam Topic 4)
Which NTP mode must be activated when using a Cisco router as an NTP authoritative server?

1. A. primary
2. B. server
3. C. broadcast client
4. D. peer

Correct Answer: D

- (Exam Topic 4)
Simulation 05


Solution:
R1
enable Config t Int loop0
Ip ospf 1 area 0 Int et0/0
Ip ospf 1 area 0
Ip ospf network point-to-point
copy run start R2
Enable
Config t Int loop0
Ip ospf 1 area 0 Int et0/0
Ip ospf 1 area 0
Ip ospf network point-to-point Int et0/1
Ip ospf 1 area 0
Ip ospf network point-to-point
copy run start R3
Enable Config t Int loop0
Ip ospf 1 area 0 Int et0/1
Ip ospf 1 area 0
Ip ospf network point-to-point
copy run start
Verification:


Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A